GE 200D2600P043 - Manual (Page 17)

1/4 ″ (6 mm) Max.
Panels thicker than 1/4 ″ (6 mm)
5/16 ″ (8 mm)
3/4 ″ (19 mm)
17
Trim kits and decorator panels.
For CustomStyle ™ models
Read these instructions completely and carefully.
Before You Begin
2 ″ (5.1 cm)
Clearance
Handle Side
Appearance
Panel
Refrigerator
Door
1/4 ″ (6 mm)
Thick Backing
3/4 ″
(19 mm)
3/4
″ (19 mm) or Raised Panel
A raised panel design screwed or glued to a 1/4
″ (6 mm) thick backing, or a 3/4″ (19 mm) routed board
can be used. The raised portion of the panel must be fabricated to permit clearances of at least 2
″ (5.1 cm)
from the handle side for fingertip clearance.
Panels thicker than 1/4
″ (6 mm), up to 3/4″ (19 mm) maximum, will require that the outer 5/16″
(8 mm) of panel perimeter be no thicker than 1/4
″ (6 mm).
Weight limitations for custom panels:
Fresh Food 38 lbs. (17 kg) max.
Freezer Door 28 lbs. (13 kg) max.
1/4 ″ (6 mm) Max.
Panels 1/4 ″ (6 mm) thick or less
Some models are equipped with trim kits that allow you to install door panels. You can order
pre-cut black, white, bisque or stainless steel decorator panels from GE Parts and Accessories,
800.626.2002, or you can add wood panels to match your kitchen cabinets.
Panels less than 1/4
″ (6 mm) thick
When installing wood panels less than 1/4
″ (6 mm) thick, you need to create a filler panel, such as 1/8″
(3 mm) cardboard, that will fit between the face of the door and the wood panel. If you are installing the
pre-cut decorator panels, pre-cut filler panels are included in the kit. The combined thickness of the
decorator or wood panel and the filler panel should be 1/4
″ (6 mm).
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions