Goldmund MIMESIS 22 - Manual (Page 6)

6
Connect the power cord to the back of the preamplifier and plug it into the nearest
wall plug. Use only a 3 lugs grounded plug, for safety and noise reasons. To get the
best sound of the preamplifier, avoid any multiple plugs or an extension cord.
Connect the interconnects between the preamp analog outputs and the power amp.
You will plug the cables to the RCA female sockets noted analog outputs.
Connect the interconnects from the source devices to the line inputs number 1 to 7.
Connect the tape machines to any inputs and to the Tape output RCA plugs.
Note 1 :
If you have purchased the special Balanced output option, you can also connect the
XLR marked analog output to the balanced input of a power amplifier. However, you
have to know this mode of connection is not providing you with the ultimate sonic
quality that a Mimesis 22 is built for providing.
Note 2 :
Do not use the input marked “Direct” if you are not using a linked configuration with a
Mimesis 20.
If you are equipped with the special software modules which allow the connection of
several units together, use the DB9 terminated cable provided with this option to
connect the Mimesis 22 to these units and follow the instructions delivered with the
software.
In that case only, use only the input marked “Direct” to connect the analog output of
the Mimesis 20 to the Mimesis 22 analog input module.
Note 3 :
If you purchased the Digital output option for the Mimesis 22, the digital output
module is activated. Without the option, this modu