Grundig 800 MILLENNIUM - Manual (Page 13)

14
LCD DISPLAY DESCRIPTION
1. TIMER - This annunciator indicates the state of the Timer
as either Active or Inactive. Refer to the 'CLOCK AND
TIMER FUNCTIONS' section on page 21.
2. LOCK - When illuminated, this annunciator indicates that
the Main 'TUNING' knob and all front panel keypads (except
for the POWER button) are not active.
3. MEMORY 00 - This annunciator indicates current
memory location from 00 to 69. MEMORY will light when
the receiver enters the memory mode. Refer to
'MEMORY FUNCTIONS' on page 19.
4. BATT - When operating on internal batteries, 'BATT'
blinks to indicate a low charge on batteries. 'ATT' Indicates
that the built-in attenuator is activated.
5. AGC FAST/SLOW - indicates the AGC setting, Slow or
Fast.
6. AM SYNC - Indicates that the AM mode of reception is
on. If SYNC is also illuminated, then the synchronous AM
mode of detection is on.
7. USB - Indicates that the upper sideband mode of
detection is on.
LSB - Indicates that the Lower sideband mode of
detection is on.
8. FM - Indicates that the FM mode of detection is on.
This mode is available only on the FM broadcast band (87
- 108 MHz).
9. SW 120 METER - Indicates the shortwave band
designators that define a range of frequencies for each
band as follows:
S h o r t w a v e B a n d D e s i g n a t o r s
Band Low Freq High Freq
120 Meter 2300 kHz 2500 kHz
90 Meter 3200 kHz 3400 kHz
75 Meter 3900 kHz 4000 kHz
60 Meter 4750 kHz 5060 kHz
49 Meter 5950 kHz 6200 kHz
41 Meter 7100 kHz 7600 kHz
31 Meter 9500 kHz 9900 kHz
25 Meter 11,600 kHz 12,100 kHz
22 Meter 13,570 kHz 13,870 kHz
19 Meter 15,100 kHz 15,800 kHz
16 Meter 17,480 kHz 17,900 kHz
13 Meter 21,450 kHz 21,850 kHz
11 Meter 25,600 kHz 26,100 kHz
10. AIR - indicates that the Aircraft band (118-137 MHz)
has been selected.
11. 7-Digit Readout - This display indicates the
operating frequency of the receiver. The frequency is
displayed in 'kHz' for the AM broadcast and Shortwave
bands. The FM and Aircraft band frequencies are
displayed in 'MHz'.
12. SCAN 00 S - Indicates that the receiver is in the
memory channel SCAN mode and displays the number of
the currently scanned channel, from 00 to 69. In the
MEMORY mode, the 'S' illuminates to indicate that a
particular memory channel will be skipped over when the
SCAN operation is activated.
13. 6.0 4.0 2.3 - Indicates which IF filter is selected.
There is no indication in the FM mode.
14. - Indicates that a stereo FM broadcast station is
tuned in.