Grundig 800 MILLENNIUM - Manual (Page 24)

25
SPECIAL USE FEATURES AND FUNCTIONS
The SATELLIT 800 MILLENNIUM receiver has several
special features that are referred to in the main body of
this Owner's manual but may require additional explana-
tion.
LOCK ALL ENTRY TO KEYPAD
The receiver front panel buttons with the exception of the
button and 'TUNING' knob may be locked or
disabled by pressing and holding the button for 3
seconds.
Press the button and hold for 3 seconds. A
confirmation beep will be heard when the is
pressed. will appear on the front panel display
after 3 seconds to indicate that the front panel buttons and
TUNING control are locked.
Press again for 3 seconds to unlock the front
panel buttons and tuning control. The beep will again
be heard when the button is pressed and the
indicator on the front panel display will disappear
after 3 seconds, indicating that the TUNING control
and front panel buttons have been released.
BROADCAST BAND TUNING STEP SIZE
In the AM broadcast band, the SATELLIT 800
MILLENNIUM receiver increments the frequency in
10 kHz steps when pressing the and buttons.
The 10 kHz step size is practical for tuning the U.S. and
Canadian broadcast bands. However, the step size can
be changed to 9 kHz to permit practical tuning of Euro-
pean broadcast stations. The tuning step size is held in
nonvolatile memory and thus is not lost during power
failure or battery changing. To select the alternate step
size:
With POWER OFF Press and hold the button
while pressing the button to put the SATELLIT 800
MILLENNIUM receiver in the POWER 'ON' mode.
If the step size was 10 kHz prior to performing the above
procedure, then the 9 kHz step size for the broadcast band is
now programmed. To change back to 10 kHz, repeat the
same procedure.
DELETE ALL MEMORY CHANNELS
If it is desired to delete all programmed memory channels,
perform the following procedure:
With POWER OFF, Press and bold the button
while pressing the button to put the SATELLIT 800
MILLENNIUM receiver in the POWER 'ON' mode.
Hold the button until a confirmation beep is heard
to indicate that ALL memory locations have been cleared.
AUTOMATIC BANDWIDTH SETTING WITH MODE
SELECTION DISABLE (ENABLE)
The SATELLIT 800 MILLENNIUM receiver permits automatic
setting of the bandwidth appropriate for each mode of
detection. For example, 6.0 kHz bandwidth would be
selected automatically for AM mode operation, and 2.3 kHz
bandwidth would be selected for SSB mode. Of course,
pressing the 'BANDWIDTH' button temporarily overrides the
automatic setting until a mode change is made. The setting,
automatic or manual bandwidth selection with mode, is held
in nonvolatile memory and is not lost during power loss or
during battery changing. To disable the automatic bandwidth
with mode;
With POWER OFF, Press and hold the 'BANDWIDTH'
button while pressing the button to put the receiver in
the POWER 'ON' mode.
To enable 'Automatic Bandwidth Selection with Mode'
operation, repeat the same procedure.