Grizzly G0466 - Manual (Page 14)

Model G0466/G0469 Air Compressors - 12
-
6. Close the drain valve (Figure 5) to
allow the tank to build up pressure.
7. Check the tank pressure gauge
( Figures 6 and 7) to see that the tank
pressure climbs to approximately 115-
120 PSI (around 8 BAR) and turns
OFF.
Note: If the compressor does not turn
OFF at 120 PSI, flip the ON/OFF switch
to OFF before the pressure reaches
the maximum PSI shown on
Page 3.
See Pressure Switch on Page 22 to
adjust the automatic shut-off.
Figure 5. Drain valve.
Figure 8. Tool air control knob.
The air tool that you attach to the air
compressor should have a preferred PSI
operating level. Set the pressure to be
delivered to the tool according to the
required level of the tool.
To control the air supply to your tool:
1. Adjust the air control knob, shown in
Figure 8, to set the PSI that will be
delivered to your tool. Turn the knob
clockwise to increase the pressure or
counterclockwise to decrease the pres-
sure.
Line Pressure
Regulation
Air Control
Knob
Lock Ring
2. Rotate the lock ring shown in Figure
8 against the bottom of the air control
knob to prevent changes in the air pres-
sure.
Figure 6. G0466 Pressure gauges.
Line
Pressure
Tank
Pressure
Figure 7. G0469 Pressure gauges.
Line
Pressure
Tank
Pressure