GE 681131689496 - Manual (Page 5)

5
Adding the Mixing Bowl
When using the large bowl, the turntable should be placed in the off-center position,
where the large bowl icon is located. Similarly, when using the small bowl, the turntable
should be placed in the center position where the small bowl icon is located.
Mixing bowls should NEVER be used in a conventional oven, microwave oven, on
top of the range or on any other heated surface. If mixing bowls are scratched or
chipped, do not use. Mixer bowl should not be used to blend in hot liquids.
Inserting the Beaters
NOTE: It is important that the beaters go into the correct sockets. Otherwise the
Mixer will not give you the proper mixing action. Do not risk ruining a recipe or
damaging your Mixer. Read the following instructions carefully.
1. Make sure the Mixer is unplugged and speed control dial is set to 0 (OFF) position.
Lift Mixer head up and back to pull it out of the way of the bowl.
The beater with the small washer (has a plastic button on the bottom) goes into the
socket on the side of the mixer nearest the side of the bowl. The beater with the
larger washer (square-shaped) goes into the socket nearest the center of the bowl.
Because each beater only fits in it’s proper socket, please follow the above instructions
when you inserting beaters. Please refer to the icons beside the sockets.
1. Small Washer Beater
2. Big Washer Beater
2. Insert the beaters one at a time by aligning the notches on the beater with the
slots on the Mixer head. Use a combination of pressing and twisting motion until
the beaters snap into position.
If a beater should not properly snap into place, pull it out of the socket and rotate it
one quarter turn. Reinsert the beater into the socket until it snaps into position.