Greenway Home Products MM255CH - Manual (Page 3)

GET READY TO START
Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use a box cutter or
exacto-knife as you may cut into the mantel pieces inside the box and damage the finish. Check for the
hardware bag which is RED and located inside the packaging, taped to the top box. Be sure you DO
NOT discard any pieces. Use an appropriate screwdriver to insert and tighten all screws.
Step 1
Locate the base and place it on the floor. DO NOT put it up against
the wall at this point in the assembly, as you need to get in behind
the mantel to insert several screws.
Step 2
Locate the left side panel and the left front panel. Facing the front of the base,
take the left side panel, positioning it so the holes in the blocks on the bottom line
up with the holes on the base. Position the left front panel next to the left side
panel, lining up the holes in the blocks with the holes on the base. Attach the left
front and side panel to the base by inserting and tightening 1 screw to each piece.
Attach the left side and left front panels together by inserting and tightening
3 screws.
Step 3
Repeat Step 2, but with the right side panel and the right front panel.
2