Gembird BTHS-002 - Manual (Page 7)

Bluetooth headset
Switching the Bluetooth
headset off
Approximately 5 seconds Will emit a red indicator light
which will stop once the
headset is off
Once the headset is switched off, the
mobile phone will use its own speaker for
the sounds
Volume mute Click and hold down the
volume adjustment button
(‘+’&’-‘) for 3-4 seconds
The Bluetooth headset will
mute the call
Redial Click and hold down the
volume adjustment button
(’-‘) for 3 seconds
Redials the last call made from
the mobile phone
The mobile phone has to support the
Bluetooth redial function
Answer a call Click the button once as
the call is coming through
Answers the incoming call
End a call Click the button once
during the call
Ends the current call
Reject a call Click and hold down the
button for 3 seconds
Reject s the incoming call
Re-connect to Bluetooth
device
Click the button once and
then click the button again
after 3 seconds
Will reconnect paired Bluetooth
devices if they have been
disconnected
Green indicator light will flash twice every
one second until the Bluetooth headset is
reconnected to the Bluetooth devices
Voice control Click the button once while
the Bluetooth headset is in
standby mode
Voice can be used for dialing,
redialing and answering calls
The mobile phone has to support this
function
Follow the instructions in the table above and prepare the Bluetooth headset for pairing
(when the headset is ready it will emit a series of flashing green and red lights). Then turn