Geneva Lab SOUNDS SYSTEM L - Manual (Page 14)

14
2. How to?
General:
How to turn the Geneva Sound System on and off?
The System is always in standby mode and can be controlled by the remote control or by
using the keys next to the Universal Dock under the lid on top of the Cabinet.
You can turn On the Geneva Sound System by any of the following actions:
- Pressing the FM, iPod, CD, or Line In keys on the remote control
- Pressing the on/off key on the remote control
- Pressing the on/off key next to the Universal Dock under the lid on top of the Cabinet.
You can turn Off the Geneva Sound System by any of the following actions:
- By pressing either the ON/OFF key on the remote control or the on/off key next to the
Universal Dock under the lid on top of the Cabinet.
How to adjust Volume and Sound?
1. Use the Volume, Bass and Treble keys on the remote control to adjust sound and
volume. You can also use the Volume key next to the Universal Dock under the lid
on top of the Cabinet to adjust the volume.
2. The volume range on display: 0 means silence (no sound output), 100 means
maximum output.
3. Treble and Bass: -6 means very little bass or treble, 0 means neutral , 6 means
maximum bass or treble.
4. If you turn the device off, the current values are stored. So if it is at a very high volume
when turned off, it will be at a very high volume when it is next turned on.
How to verify that the remote control works?
Every time a key is pressed on the remote control, a small red light on the LED Display
lights up quickly.
How to clean the speaker?
Unplug this Geneva Sound System from the AC power outlet before cleaning. Clean only
with a dry cloth. To avoid making scratches to the surface, we recommend that you use
the cleaning cloth included in the accessory bag.
Warning – Do not use cleaning alcohol, or other solvent fluids to clean the surface of the
Cabinet as this can both damage the lacquer and also cause electrical failures and fire if
it enters the electronics in the Geneva Sound System!