GameTime PM0503-08 - Manual (Page 5)

COPYRIGHT © 2006 MERIT ENTERTAINMENT
Game Description
The Megatouch Gametime unit has an
Ethernet coupler installed in the rear of the
game (see Figure 1). The coupler can be
used for Internet connection or linking games
together for head-to-head play. Several up-
grade kits are also available for purchase
through your local authorized dealer, includ-
ing a wireless kit (part number: KAV-100-
011-02) and a keyboard kit (part number:
KAV-100-014-01). The wireless kit uses a
wireless adapter and the USB port on the
back of the game to wirelessly connect to
the Internet or link games, while the key-
board kit allows you to easily type text in a
Web browser. The centronics connector
on the back of the game is used for future
software upgrades.
Control Board Compartment
The control board compartment is located at
the rear of the game (see Figures 1 and 2).
Loosen the two thumbscrews to open the
compartment. The buttons on the control
board are explained below.
SETUP
Press SETUP to access the software op-
tions. These options are explained in the
software section of this manual. If SETUP is
pressed during boot-up, the on-screen DIP
switch program will launch. Consult the DIP
SWITCH SETTINGS section of this manual
for more information.
CALIBRATE
Pressing the CALIBRATE button will take
you through the steps to calibrate the
touchscreen. This is sometimes necessary
if the touchscreen is not responding prop-
erly to touch. See Touchscreen Calibra-
tion for detailed instructions.
MONITOR CONTROLS
The five buttons labeled Auto, Exit, Left,
Right, and Menu adjust the monitor settings.
See Monitor Adjustment Procedure for
detailed instructions of each button.
General Care and Maintenance
Touchscreen Calibration
• Press the CALIBRATE button, located
in the control board compartment (see
Figure 2). Touch the center of the first
cross that appears on the screen.
Once you release your finger, a sec-
ond cross will appear.
NOTE: You must hold your finger on
the circle for approximately 2 seconds
for the calibration to be recognized.
•
Touch the center of the second cross
that appears on the screen.
•
Once the second cross is touched and
released, another cross will appear on
the screen. To test the calibration of
the screen, touch the cross with your
finger and slowly drag your finger
around the screen. The cross should
follow your movement.
•
Touch the EXIT button, then perform
the operation a second time for high
resolution.
FIGURE 2 - CONTROL BOARD DRAWING
3 MEGATOUCH GAMETIME OWNER’S MANUAL PM0503-08
SECURITY KEY
CALIBRATE SETUP
MONITOR CONTROLS