En g lis h – GN Netcom BT250v User Manual
Page 5
8
En
g
lis
h
9
En
g
lis
h
Jabra BT250v is ready to wear on the right ear. If
you prefer the left, gently rotate the MiniGel 180°.
For optimal performance, wear Jabra BT250v and
your Bluetooth phone on the same side of your
body. In general, you will get better performance
when there are no obstructions (including parts of
your body) between the headset and the phone.
Choosing wearing preference
7
Fig. 4
Ending a call
9
Making a call
8
If Jabra BT250v is off, turn it on now (see Turning headset on/off section).
Using phone’s keypad
1. Dial number on keypad.
2. Press phone’s “send” key.
Using voice-activated dialing (after you’ve set up voice tags on your phone)
1. Press and release once. You’ll hear 1 short beep while doing this.
2. You’ll then hear the voice-activation tone; say the name of the person you wish to call.
NOTE: Record voice tag from headset for better reception.
•
Press and release once
OR
•
End call from phone’s keypad
Call-waiting*
11
Answering a call
10
•
After you hear the ring tone, press and release once
OR
•
Answer the call with your phone’s keypad. You may then need to transfer the call to
the headset by pressing and releasing once (depending on your phone)
IMPORTANT: Do not hold the button down for more than 3 to 5 seconds when
turning the headset on or else it may go into pairing mode, and the blue indicator light
will turn solid. If that happens, turn off the headset, wait 3 to 5 seconds, and repeat
process for turning the headset on.
•
(Recommended) Use standard method from your phone’s keypad which typically
involves pressing the “send” button
OR
•
Press and release once to answer the incoming call and toggle between calls
(some phones do not support this headset feature)
* See Enhanced features section for alternative call-waiting instructions for
phones that support the hands-free profile.
IMPORTANT: Do not hold the button down too long when making, ending, or
answering a call. This should only be a quick tap, so you don’t put the headset into
pairing mode by accident.