GE 20621 - Manual (Page 11)

11
Setting ALL Volume/Mute Control to any one Mode
This routine can set all Modes to “punch-through” to any one
chosen Mode for Volume/Mute button control without the needing
to change to that Mode.
1. Press and hold the SETUP button until the red
indicator turns on, then release the button.
2. Press and hold the MUTE button until the red
indicator blinks off, then release the button.
3. Press and release the desired Mode button ( TV, DVR,
etc.) for Volume/Mute control, the red indicator blinks
then stays on.
4. Press and release the MUTE button and the red
indicator turns off. The red indicator will blink rapidly
for three seconds if the Mode you have selected has
no Volume/Mute control.
All other Modes will now punch-through to your chosen
Mode for Volume/Mute control.
Setting any Mode to use its own Volume/Mute Control
This routine can set any Mode to use only its own Volume/Mute
control. Note - If your chosen Mode has no Volume/Mute functions
of its own then the Volume/Mute buttons will do nothing.
1. Press and hold the SETUP button until the red
indicator turns on, then release the button.
2. Press and hold the MUTE button until the red
indicator blinks off, then release the button.
3. Press and release the desired Mode button ( TV, DVR,
etc.), the red indicator blinks then stays on.
4. Press and release the VOLUME- (Down) button, the
red indicator blinks then stays on.
. Press and release the MUTE button and the red
indicator turns off.
Your chosen Mode will now use its own Volume/Mute
control.
Using Your Remote, cont.