GE MG27006 - Manual (Page 11)

11
Programming the Remote to Control
an RCA Audio Device:
Your remote controls only RCA audio equipment such as an audio
receiver or amplifier—it does not control other brands of audio
equipment. Also, the remote may need to be programmed for your
equipment. This remote may not operate all of the components listed at
the end of this section. Use the codes at the end of this section or on
the sheet packed in with your remote.
1. Turn on the component to be programmed.
2. Look up your brand and its code number(s) on the code list.
3. Press and hold the AUDIO button.
4. Enter the code from the code list.
5. Release the AUDIO button and press POWER or CHAN (channel
up) or CHAN (channel down) to see if the audio device responds
to the remote commands.
Using the Remote to Control a Device
Once the remote has been programmed successfully, you are ready to
use it to control your devices.
To operate the device:
1. Press the device button (TV, VCR1, VCR2•LD, or SAT•CABLE) to set
the remote to control the device.
2. Press POWER to turn the device on or off.
3. Use the remote buttons that apply to that device.
Using the Remote