GE MG27006 - Manual (Page 4)

4
Setup and Connections
Step 1:
Unpack the TV and remote control.
Step 2:
Connect your TV. Connect the cable from your cable system or off-air
antenna to the cable in-jack on the back of the TV, as shown.
Step 3:
Plug in the TV. Plug the end of the power cord into the wall outlet,
matching the wide blade of the plug with the wide slot in the outlet. Be
sure to insert the plug completely.
Step 4:
Put batteries in the remote.
1. Remove the battery compartment cover from the back of the
remote.
2. Insert batteries as shown, matching the + and – ends of each
battery in the compartment.
3. Replace the cover.
Step 5:
Turn on the TV.
• Press the TV button on the remote.
Read the next section, The Menu System, which is a brief overview of
the basic rules for getting around in the menus using the remote or the
TV's front control panel.
Step 6:
Auto Channel Search.
Perform an Auto Channel Search (described in the Channel menu
section).
TV
ANTENNA, CABLE, CABLE BOX OR VCR
CABLE/
ANTENNA
Getting Started
Caution: If you choose to use a stand
with your TV, take precautions that the
stand or other furniture the TV is placed
on is properly located and of adequate
size and strength to prevent the TV from
accidentally being pushed off, pulled off,
or tipped over. This could cause damage
to the TV and/or personal injury.