Grizzly H6310 - Manual (Page 8)

Model H6310 Jump Starter/Compressor -6 -
SET UP
Unpacking
Your jump starter/compressor left our
warehouse in a carefully packed crate or
box. If you discover damage after you have
signed for delivery, please immediately
call Customer Service at (570) 546-9663
for advice.
Save the containers and all packing materi-
als for possible inspection by the carrier or
its agent. Otherwise, filing a freight claim
can be difficult.
When you are completely satisfied with
the condition of the shipment, you should
inventory the equipment.
Inventory
After you have unpacked the carton you
should find the following.
Model H6310 Inventory (Figure 1)
A. Main Unit ............................................ 1
B. Charging Adapter Cord ...................... 1
C. 12V Output Cord ................................ 1
D. Securing Strap ................................... 1
Charging
The Model H6310 is shipped with a charg-
ing adapter that fits neatly into the storage
compartment.
To charge the Model H6310:
1. Remove the charging adapter from the
storage compartment, and plug it into a
110V electrical outlet.
2. Turn the main power switch ON, and
press the "Test" button so the voltage
meter shows the charge.
3. Plug the adapter cord into the
"Recharge" socket.
— The red light will light up if the Model
H6310 is charging.
— If the red light will not light up, the
Model H6310 is fully charged.
4. Allow the Model H6310 to charge until
the red light turns off or until the volt-
age meter reaches 13V.
5. Disconnect the Model H6310 from the
charger.
NOTICE
DO NOT charge the Model H6310 for
longer than 24 hours or internal dam-
age may result.