Graco SMART SEAT PD163434A - Manual (Page 32)


1. Remove LATCH from storage area
A
. For ease of installation, extend LATCH to
its maximum length.
2. Place base in vehicle seat as shown
B
.
3. Make sure LATCH is routed through vehicle/LATCH belt path normally used
for vehicle seat belt.
Belt must lay flat and not be twisted.
4. Hook Connectors to vehicle lower anchors. Pull firmly on Connectors to be
sure they are attached
C
.
5. NEVER put two LATCH connectors on one vehicle LATCH anchor unless
specifically allowed by the vehicle manufacturer D .
6. With base flat on vehicle seat, slide back until top of base contacts seat back.
Make sure that base bottom remains flat on the vehicle seat
E
.
7. Tighten LATCH by pushing down hard on the center of the base and pulling
the free end of the adjustment belt F .
8. Test base for secure installation by moving front to back and left to right at
the belt path G . Base should not move more than 1 inch ( 2.54 cm). If belt
loosens or lengthens, repeat procedure.
9. Check that the LATCH stays tight and does not slip from the tightened
position. If it does not stay tight, try another seating position or contact Graco
at 1-800-345-4109.
10. To remove LATCH lift up on metal tongue of buckle and remove LATCH as
shown
H
.
10.0 Installing Base U
sing L
AT
CH