Graco SMART SEAT PD163434A - Manual (Page 34)

F
D
A

1. Test base for secure installation. See sections 9.0 and
10.0 for base installation, p. 30-33
A
.
2. Push in
B
and rotate knobs
C
on both sides of child
restraint at the same time to unlock position.
3. Place child restraint on base in rear-facing position D .
4. Rotate knobs on both sides of child restraint to lock it
into base
E
. You will see lock symbols in windows on
side of base as shown
H
.
5. If you see the red flags up in the child restraint
seating area F and you see the unlock symbol I
then seat is not secured to base.
6. Check seat is secure by moving front to back and left
to right at the belt path
G
. Base should not move
more than 1 inch ( 2.54 cm). If belt loosens or
lengthens, repeat procedure.
NOTE: Make sure tether is stored. See “14.1 Tether
Storage”, p. 39. You can not use tether in rear-facing
mode.
NOTE: Bubble in level indicator must be fully
between the two lines
J . Level indicator is for
rear-facing use only. See “17.0 Using Recline”, p. 44
11.0
REAR-F
ACING
INST
ALL
ATION