Installation instructions, Step 9 install trim pieces, Step 8 slide dishwasher partially into cabinet – GE PDW8100 User Manual

Page 7: Step 7 install drain hose, guide through cabinet, Step 6 position water line and house wiring

Advertising
background image

Power Cord

(If Used)

Water

Line

House

Wiring

Drain

Hose

Insulation

Blanket

Installation Instructions

7

STEP 9 INSTALL TRIM PIECES

Skip this step if trim is not supplied with the
dishwasher.
• Locate trim strips inside dishwasher.
• Press trim onto the tub flange on each side. Start with

the top edge, pressing on as you move towards the
bottom.

• Press the two top trim pieces on each side of the latch.
• Open and close the door to check that trim does not

bind and does not interfere with door latch.

Figure R

STEP 8 SLIDE DISHWASHER

PARTIALLY INTO CABINET

DO NOT PUSH AGAINST FRONT PANEL WITH KNEES.
DAMAGE WILL OCCUR.
• Slide dishwasher into the opening a few inches at a

time.

• As you proceed, pull the drain hose through the open-

ing under the sink. Stop pushing when the dishwasher
is a few inches forward of adjacent cabinetry.

• Make sure drain hose is not kinked under the dish-

washer and there is no interference with the water
line and wiring or any other component.

Figure Q

• Position the dishwasher in front of the opening.

Insert drain hose into the cabinet side. If power cord
is used, guide the end through a separate hole.

Figure O

STEP 7 INSTALL DRAIN HOSE,

GUIDE THROUGH CABINET

• Remove tape and wire tie holding the clamp to the

drain hose. Be careful not to damage the drain hose.

• Stand the dishwasher

upright.

• Slip the supplied

hose clamp over the
small end of the hose.
Do not tighten.

STEP 6 POSITION WATER LINE

AND HOUSE WIRING

• Position water supply line and house wiring on the

floor of the opening to avoid interference with base
of dishwasher and components under dishwasher.

Figure N

Do Not Push Against
Front Door Panel With
Knee. Damage to The
Door Panel Will Occur.

Trim Strip

Trim

Strip

Trim

Strip

• Push hose over the drain outlet on the back side of

the dishwasher. See illustration. Push the hose over
the outlet and against the shoulder stop.

• Tighten the hose clamp with a 1/4" nut driver.

Figure P

Drain

Outlet

Hose

Clamp

Shoulder

Stop

Water

Line

House

Wiring

5"

5" 4"

6"

4"

Advertising
This manual is related to the following products: