GE 197D4613P004 - Manual (Page 5)

You can turn the light ON or OFF by pushing the
light switch located on the right side of the control
panel housing. If the interior light is left on,
it will raise the inside temperature.
About the control and settings.
ge.com
C
o
n
su
m
e
r
S
u
p
p
o
rt
T
ro
u
b
le
sh
o
o
tin
g
T
ip
s
O
p
e
ra
tin
g
In
st
ru
c
tio
n
s
S
a
fe
ty
In
st
ru
c
tio
n
s
In
st
a
lla
tio
n
In
st
ru
c
tio
n
s
C
a
re
a
n
d
C
le
a
n
in
g
Control Settings
The temperature range of the beverage center/
wine chiller is intended for 40°F (4,4°C) to 60°F
(15,6°C). The display shows the average
temperature of the appliance. It is normal
for the actual temperature to vary slightly
during operation.
Auto Temperature Setting
When the appliance is plugged in or the “+” pad
is pressed, the appliance runs on the “Auto Bev”
setting of 44°F (6,7°C) and the “Auto Bev”
indicator light in the upper left corner stays lit.
NOTE: Display will flash when the “+” pad is
pressed.
Normal Temperature Setting
The temperature of the beverage center can
be set anywhere between 39°F (3,9°C) to 61°F
(16,1°C) by the “+” and “–” pads.
Press and hold the SET pad. You will hear
a series of 2 beeps.
After the second beep, press the “+” and “–”
pads to increase or decrease the desired
temperature in increments of one degree.
During this time the display will flash.
Press SET to confirm your choice. The display
will stop flashing. If no confirmation is made
in ten seconds, the unit will automatically
accept your change.
NOTE: When you change the temperature
setting, there may be a 5-minute delay until
the compressor starts to run.
Fahrenheit and Celsius
The temperature display can be changed
between Fahrenheit and Celsius by pressing and
holding the “+” pad for approximately 5 seconds.
Indicator Light
The indicator is lit when the compressor is
running to cool your unit. It will not be lit when
the compressor is idle.
Interior Light
To switch the interior light on/off, simply press
the
pad.
5
Interior Light
Auto Bev
Indicator Light
After plugging in the beverage center/wine
chiller and setting the desired temperature,
allow the beverage center/wine chiller to reach
the set temperature before loading your wine.
The temperature may take up to 12 hours to
completely stabilize.
After loading the wine or beverages, you may
notice the actual temperature rise. This is normal.
The actual temperature will continue to change
as the wine and beverages are cooled to the set
temperature. The temperature may take up to
12 hours to completely stabilize.
A guide with wine serving temperature suggestions
is located on the inside right portion of the unit.
It gives recommended temperatures for different
wines, as well as instructions on adjusting the
temperature of the beverage center/wine chiller.
NOTE: The exterior of the cabinet may get warm.
This is normal.
When the Beverage Center/Wine Chiller is Plugged In