Gefen EXT-HDMI-CAT5-844 - Manual (Page 10)

7
How to Connect the 8x4 CAT-5 Matrix for HDMI
1. Connect up to 8 HDMI source devices to the 8x4 CAT-5 Matrix for HDMI
using the included HDMI cables.
NOTE: Please be aware that each input has two available HDMI ports and that
only one will be active at any given time. It is recommended that commonly used
HDMI sources be put on separate inputs (i.e. 1A and 2A, not 1A and 1B) so that
these devices are always available.
2. If using the extension functionality of the 8x4 CAT-5 Matrix for HDMI, please
connect the HDMI output ports to the HDMI extension input ports using the
supplied 1 foot jumper cables. Please see the diagram on the next page for
extension input port connection instructions.
NOTE: All of the extension input ports are available for use but are not required
for operation. The HDMI output ports can be used to directly connect a local
display, or can be used in conjunction with the jumper cable to access the
extension functionality of the 8x4 CAT-5 Matrix for HDMI.
3. Connect any local displays to the 8x4 CAT-5 Matrix for HDMI output ports
using user supplied HDMI cables.
4. Connect both DDC and Video CAT-5e cables for each extension that is
going to be used.
5. Connect both DDC and video CAT-5e cables, at the end of each cable run,
to a HDMI Over CAT5 Receiver.
6. Connect the remote display(s) to each HDMI Over CAT5 Receiver using a
user supplied HDMI cable.
7. Connect the included 5V DC power supply to each of the HDMI Over CAT5
Receivers.
8. Connect the included 24V DC power supply between the power input on the
unit and an open wall power socket.
9. Power on all output devices fi rst and the source devices second.
How to Operate the 8x4 CAT-5 Matrix for HDMI
The 8x4 CAT-5 Matrix for HDMI can be controlled by the optional RMT-16IR
remote control or the RS-232 serial communications port.
For RMT-16IR remote control functions please see page 9.
For RS-232 serial communication functions please see page 14.
CONNECTING AND OPERATING THE 8X4 CAT-5 MATRIX FOR HDMI