GE 00023598 - Manual (Page 10)

10
Wall Mounting the Phone
1. To prepare for wall mounting, wrap excess
telephone cord, if any, around the hooks
provided on the wall mount bracket. Be sure to
leave enough cord for connecting to the base at
the top and the wall jack through the center cut
out of the wall bracket.
2. Plug the line cord into the jack of the base.
3. Align the line cord with the small cut out in the
wall mount bracket.
4. Align and inset the two sets of small tabs of the wall mount bracket into the base
at the top. Then gently press into the two sets of bottom grooves until it snaps in
place.
5. Connect the small end of the power adapter into the POWER 7.5V AC jack on the
back of the answerer. Secure the cord of the power adapter in the groove on the
wall mount bracket.
6. Carefully turn the handset hook180 with a coin or screwdriver until it points
upward (the WALL imprint will be right side up). You need to do this so the at the
handset doesn’t fall out of the base.
7. Connect the line cord to the wall phone jack, through the center cutout of the wall
mounting bracket.
8. Slip the mounting of the base (on bottom of unit) over the wall plate post and slide
the base down until the phone is firmly in place.
9. Plug one end of the coiled cord into the handset. Plug the other end into the jack
on the side of the base.
10. Place the handset on the base.
11. Plug the AC Power adapter into an AC power outlet. The screen displays
PLEASE
WAIT… then announces: “Press menu key to set up unit”. The unit is ready for
Answering System Set Up.