GoVideo DHT7100 - Manual (Page 30)

24 DVD System User’s Guide
D I G I T A L O U T P U T F O R M A T
If you have connected the DHT7100 to an A/V
receiver with a Dolby Digital and/or DTS decoder,
you can specify the format of the outgoing digital
audio signal.
1. While the player is in Stop mode, press the
SETUP button.
2. Use the LEFT/RIGHT ARROW keys to select
“System.”
3. Use the UP/DOWN ARROW keys to select
“Digital Output,” then press ENTER.
4. Use the UP/DOWN ARROW keys to set the
Digital Output to:
B i t s t r e a m
Sends a digital signal that carries the Dolby Digital
5.1 and/or DTS multichannel information to your
external decoder.
L P C M
Sends a linear PCM (Pulse Code Modulation), or 2-
channel stereo signal, to your A/V receiver.
5. Press ENTER to confirm your selection.
6. Press the SETUP button to exit the menu system.
R A T I N G L E V E L S
The DHT7100 features a password-protected rating
system to prevent playback of DVDs with objection-
able material.
1. While the player is in Stop mode, press the
SETUP button.
2. Use the LEFT/RIGHT ARROW keys to select
“System.”
3. Use the UP/DOWN ARROW keys to select
“Rating Level,” then press ENTER.
4. Use the 0-9 keys to enter a 4-digit password,
then press ENTER.
• The player’s password is set to “7890” by
default.
5. Use the UP/DOWN ARROW keys to select either
RATING LEVEL or NEW PASSWORD, then press
ENTER.
• 1 is most restrictive, and 8 is least restrictive. If
6 is selected, a disc rated 7 or above cannot
be played.
• If you select NEW PASSWORD, the screen
changes and enables you to enter the new
password.
6. Press the SETUP button to exit the menu system.
Set the Digital Out to
Bitstream or LPCM
I F Y O U F O R G E T Y O U R
P A S S W O R D :
While the player is in Stop mode, hold the
STOP button down on the front panel for
at least 5 seconds. “INITIAL” will appear
on the front panel display and all default
settings will return to their factory presets.