Memorex MT1701 - Manual (Page 17)

16
WALL MOUNTING THE UNIT
Detach the stand cover by pulling it outward
as per arrow A.
A
1
Remove the four (4) screws (A) using a
phillips head screwdriver and remove the
handle.
Remove the four (4) screws (B) using a
phillips head screwdriver and remove the
stand.
A A
A
B
B
A
B
B
2
This monitor conforms to the VESA Flat
Panel Mounting Physical Mounting Interface
Standard which defines a physical mounting
interface for flat panel monitors, and
corresponding standards for flat panel
monitor mounting devices, such as wall and
table arms. The VESA mounting interface is
located on the back of your monitor. The
VESA Mounting slots of this model are
located inside the handle cover (shown in
the following figure).
To mount the monitor on a swing arm or
other mounting fixture, follow the instruction
included with the mounting fixture to be
used.
100mm
4mm, 0.7pitch threaded
holes x4
100mm x 100mm
Screw Mounting Options
100mm
3