Memorex MT1701 - Manual (Page 25)

TV OPERATION
24
Adjust the volume level by pressing the VOLUME Up ❶ or
Down ❷ button. The volume level will be indicated on the
screen by green bands and a green numerical display
between 0 and 24 where 0 is the lowest setting and 24 is
the loudest.
2
1
3
For proper operation, before selecting channels, they
must be set into the TV’s program memory, see page 22.
Press and release the CHANNEL Up 1 or Down 2 button.
The TV automatically stops at the next channel set into
memory. This will not operate if channels are not set into
memory.
Direct Program Selection buttons (0 - 9)
Use these buttons to select a channel. The channel number
will appear at the top right corner of the screen.
• Select a channel using the Direct Channel Selection
buttons 3 and the channel will change in approximately
two seconds.
2
3
1
4
Select the TV or CATV option as described on page 17.
2
Press the POWER button to turn on the TV; the POWER
indicator will light green.
1
OPTIONS
TV:
If using a
VHF/UHF
antenna.
CATV:
If using Cable
TV.
NOTES:
• When TV/CATV option is set to TV, only channels up
to 69 can be selected. When set to CATV, channels
up to 125 can be selected.
• If an invalid channel is selected, the display will revert
to the original channel.
FAQs:
Why do I only receive 69 channels, when my cable goes much higher?
TV/CATV option must be set to CATV when using cable, see page 17.
Why are some channels scrambled?
You must subscribe to these channels through your cable company.