Connecting the satellite dish, receiver, and tv – Motorola Vanguard 305 User Manual
Page 39
Installation
DSR305 User Guide
31
Connecting the Satellite Dish, Receiver, and TV
Make sure that the satellite receiver is not plugged into a power source before you
connect any cables to the receiver and complete the following steps:
•
Connect the cable from the satellite dish to the satellite terminal on the satellite
receiver's back panel. Connect a three-wire (red, yellow, and white) cable from
the TV terminal on the satellite receiver's back panel to TV IN (or coaxial
cable to VHF IN) terminal on your TV.
•
On the back panel of the satellite receiver, set the CH3 CH4 switch (which is
located just above the TV terminal) to whichever channel provides the clearest
reception to the same channel that you set on your TV.
•
Turn on the TV and tune it to channel 3 or 4 to match the position of the switch
on the back panel of the satellite receiver.
•
Plug the satellite receiver power cord into a standard power outlet. Wait one
minute, and then press the POWER key (green) on the left side of the satellite
receiver's front panel.
305.book Page 31 Tuesday, April 15, 2003 11:15 AM