Using the remote control, En – 8 battery installation, Operation area (for wireless control system) – MITSUBISHI ELECTRIC X500 User Manual

Page 8: Using the wired remote control

Advertising
background image

EN – 8

Battery installation

Use two AA size batteries.
1. Remove the back cover of the remote control by pushing the battery compartment door in the direction of the

arrow.

2. Load the batteries making sure that they are positioned correctly (+ to +, and - to -).

3. Replace the back cover.

Important:
• Do not use a new battery with an old one.
• Load batteries in the correct position.
• Do not heat, take apart, or throw batteries into fire.
• Do not try to recharge batteries. Do not use rechargeable batteries.
• If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes

in contact with your eyes, rinse them with water and then consult your doctor.

Operation area (for wireless control system)

The range for operation is about 10 m (about 32 feet) when the remote control points to the projector. The dis-
tance to the screen back to the projector must be less than 7 m (about 23 feet). Depending on the type of the
screen, the distance will be different.

Important:
Avoid the direct sunlight or fluorescent light to the remote control sensor. Also keep the distance of more than 2 m
between the remote control sensor and fluorescent lamp on the remote control may not work correctly.

Using the wired remote control

Attached remote control for this projector can be used as a wired remote control with remote control cable. Wired
remote control is useful for operating in a distance or outside of the operating area.

20˚

15˚

20˚

15˚

30˚

30˚

20˚

20˚

1

2

3

REMOTE

AUDIO 2 IN

COMPUTER 2 IN

AUDIO OUT

COMPUTER OUT

AUDIO 1 IN

COMPUTER 1 IN

DIGITAL
ANALOG

INPUT SELECT

MAIN

AC IN

O

I

L

R

S-VIDEO

VIDEO

AUDIO

VIDEO 1 IN

VIDEO 2 IN

USB

RS-232C

• When the remote control is connected with remote

control cable, it does not work as a wireless
remote control.

• When you need a longer cable, use a pin-pin cable.
• When using the wired remote control, the laser beam may be darker. It is normal.

Using the remote control

Advertising
This manual is related to the following products: