Multi-Tech Systems Modem Module MT3334SMI - Manual (Page 48)

ModemModule Developer’s Guide
MT3334SMI 48
+FPTS Page Transfer Status
Command syntax: +FPTS=<ppr>
1: MCF Page good
2: RTN Page good; retrain requested
3: RTP Page good; retrain requested.
+FRBC Phase C Receive Data Block Size
Command syntax: +FRBC=<value>
0: Stream mode, Phase C data is terminated by <DLE><ETX>.
+FREL Phase C Received EOL Alignment
Command syntax: +FREL=<value>
0: Indicates that EOL patterns are aligned as received (Default).
1: Indicates that the last received bits of EOL patterns are byte aligned by
DCE, with necessary zero fill bits inserted. There are two 2-byte patterns:
+FBOR binary EOL pattern
0 0000xxxx 10000000
1 xxxx0000 00000001
xxxx represents previous data bits, zero bits, or other leading data.
+FSPL Request to Poll
Command syntax: +FSPL=<value>
0: Indicates that the DTE does not want to poll.
+FTBC Phase C Transmit Data Block Size
Command syntax: +FTBC=<value>
0: Stream mode, Phase C data is terminated by <DLE><ETX>.
+FCFR Indicates Confirmation to Receive
Syntax: +FCFR
Usage: Indicates the reception of an acceptable TCF training burst and valid DCS signal
from the remotemachine.
+FCON Facsimile Connection Response
Syntax: +FCON
Usage: Indicates connection with a FAX machine. Generated in response to an originate
command or answer command.
+FCSI Reports the Remote ID
Syntax: +FCSI:”<CSI ID string>”
Usage: Reports the called station’s ID.
+FDCS Reports DCS Frame Information
Syntax: +FDCS:VR,BR,WD,LN,DF,EC,BF,ST
Usage: Reports negotiated parameters for the current session. The subparameters are
described in the +FDCS command description.