Multi-Tech Systems Modem Module MT3334SMI - Manual (Page 47)

Chapter 4 - Class 2 Fax Commands
MT3334SMI 47
+FK Session Termination
Command syntax: +FK
This command causes the modem to terminate the session in an orderly manner.
+FLID Local ID String
Command syntax: +FLID=”<local ID string>”
Valid values: ASCII string can be up to 20 characters
Response syntax: +FLID=?
Return value: (20),(32 - 127)
+FLNFC Page Length Format Conversion
Command syntax: +FLNFC=<value>
0: Disables mismatch checking. The DTE must check the +FDCS:LN
subparameter and transfer matching data.
+FLPL Indicate Document to Poll
Command syntax: +FLPL=<value>
0: Indicates that the DTE has no document to poll.
+FMDL Request Model Identification
Command syntax: +FMDL?
Response value: The information text cannot exceed 2048 characters.
This command causes the modem to send one or more lines of information text which is used to
identify the product .
+FMFR Manufacturer Identification
Command syntax: +FMFR
Response value: The information text cannot exceed 2048 characters.
This command causes the modem to send one or more lines of information text which is used to
identify the manufacturer.
+FREV Request Product Revision Identification
Command syntax: +FREV?
Response value: The information text cannot exceed 2048 characters.
This command causes the modem to send one or more lines of information text which is used to
identify the version, revision level or data, or other pertinent information.
+FPHCTO DTE Phase C Response Time-out
Command syntax: +FPHCTO=<value>
value = 0—255 (100 ms units)
Default value: 30
This value determines how long the modem will wait for a command after
reaching the end of data when transmitting in Phase C.