Motorola DVR530 - Manual (Page 18)

18
System Settings: Option 2. Audio Settings
From the System Settings menu select Audio Settings (option 2). If you are in SAT mode
(digital) broadcast, three options appear on the Audio Settings menu.
AudioConnections. Select Audio Connections, and you will be able to select either TV, HiFi,
or No Compression (the default is HiFi). Select TV if the receiver’s AUDIO OUT port is con-
nected to your TV. Select HiFi if it is connected to your stereo system. Select No Compression
if connected to a home theater system.
Analog Audio. The Analog Audio option allows you to set the output of your stereo audio
jacks. The options are Mono, Stereo, or Surround. The default is Surround.
Digital Audio. The Digital Audio option allows you to set the output of the digital audio jacks.
The options are PCM and Dolby Digital. The default is Dolby Digital.
Systems Settings: Option 3. Installation Settings
The Installation Settings menu allows you to tune in the satellite signal, change the remote
control address and initiate a manual reportback.
1. Tune Satellite Signal. This option is for the installer use only.
2. Remote Control Address. This option allows you to set the remote control address of
the satellite receiver. You can set up to eight separate addresses (0000 through 0007). The
default address is 0000.
From the Main Menu choose System Settings, and Installation Settings (option 3).
- On the Installation Settings menu, choose Remote Control Address (option 2). Follow the
instructions on the Remote Control Address screen.
To program a remote control for each receiver, hold down the SAT key on the remote control
until the light flashes then enter the four digit address that matches the receiver.