Marantz RC3001 User Manual

Page 14

Advertising
background image

9

ENGLISH

USING THE REMOTE CONTROLLER
WITH INFRARED RAYS

By default, the remote controller uses infrared
(IR) signals to operate devices.
This means that you have to point the IR sending
eye of the remote controller towards the devices
you are operating.
Operate the device with the remote controller
within the range of the illustration below.

AV S

UR

RO

UN

D R

EC

EIV

ER

SR

800

1

PH

O

NE

S

STA

NDBY

L

C

R

SL

S

SR

LFE

DIG

ITAL

SUR

ROU

ND

DIS

P

MUL

TI

AU

TO

TUN

ED

ST

SP

KR

A B

V-O

FF

NIG

HT

PE

AK

ANA

LO

G

DIG

ITA

L

AT

T

SL

EE

P

SU

RR

DIR

EC

T

AUT

O

DI

SC

6.1

MT

X 6

.1

PCM

AA

C

AU

X 1

IN

PU

T

AU

DI

O

S-V

ID

EO

DIG

ITA

L

VID

EO

L

R

ENT

ER

DO

W

N

U

P

VO

LU

M

E

PO

W

ER

O

N/O

FF

IN

P

U

T SE

LE

C

TO

R

60°

Appro

x. 5 m

Precautions:
• Do not allow direct sunlight, an inverter

fluorescent light or other strong source of
light to shine onto the player s infrared signal
reception window (remote sensor). Otherwise,
the operation of the remote controller may be
disabled.

• Bear in mind that operating the remote

controller may cause other devices operated
by infrared rays to be operated by mistake.

• The remote controller cannot be operated if

the space between the remote controller and
the device s remote sensor is obstructed.

• Do not place any objects on top of the remote

controller. Doing so may cause one or more
buttons to be held down which will cause the
batteries to run down.

USING THE REMOTE CONTROLLER
WITH RADIO FREQUENCY

You can choose to operate devices using Radio
Frequency (RF) signals instead of IR signals.
RF signals can, unlike IR signals, go through
obstacles like furniture or walls.
The RF signals sent out by the unit are picked up
by the RX3001 RF Extender.
The RX3001 translates the RF signals in
IR signals and sends the IR signals to the
appropriate devices.
Therefore, the RX3001 has to be placed near
the devices you are operating with the RX3001 s
sending eye pointed to the device or the RX3001
is connected to IR Emitters referring to page
10, 11.
The devices will always receive IR signals either
directly from the RC3001 or from the RX3001.

Precaution:

This product would not perform normally under a
strong electrostatic environment.

CHANGING THE IR / RF SETTINGS

All devices are set up by default to work with IR
signals.
To be able to operate one or more devices
with RF signals, you have to change the IR/RF
settings of the RC3001 by PC editor Wizz.it3
for those devices.

Advertising