Marantz RC3001 - Manual (Page 30)

25
ENGLISH
4. STATUS INDICATOR
This displays the settings made in the MAIN
MENU and the status of the remote device.
CHECKING THE STATUS
1. Display the MAIN MENU on the LCD of the
RC3001, then press the button next to the
STATUS indicator.
2. Pressing the ENTER button cycles through
the statuses of each of the items below.
• Remaining learning memory
• Remaining macro steps
• LCD timer setting
• Backlight timer setting
• Beep setting
• Firmware version
• Current clock time
Either press the ENTER button or wait
three seconds so that the LCD returns to
the MAIN MENU.
5. RESET
If the RC3001 is not operating properly, use the
procedure below to perform a reset (restart).
Performing a reset does not erase the settings
in the RC3001.
1. Remove the battery case cover.
2. Use a paper clip or other object to press the
reset button in the reset hole as shown in
the fi gure below to reset the RC3001.
Note:
Perform the reset with the battery pack loaded.
6. PROGRAMMABLE CODES
NUMBER OF PROGRAMMABLE CODES
This remote control has Flash memory 4M
bit (512KB) that enables it to program remote
control signals include the learned codes for up
to 8000 codes.
This number is for Marantz remote control
codes.
The actual number of codes may be less than
8000 depending on the type of the programmed
remote control signals.
PROGRAMMABLE CODES
This remote control may be unable to learn the
codes for some AV equipment due to the code
types, system, or other differences.