Maxon Telecom SP210 - Manual (Page 16)

Maxon SP200/210 Radio SP200/210
INSTALLATION, COMMISSIONING & ALIGNMENT - Issue 1.0
Page 4-2 03/01
The Accessory connector is wired as follows:
PTT / Mic
Ground
Speaker
Figure 4-2 – Connections
The small multi-pin connector, which is connected
to the other end of the test lead, is wired
as follows:
1
2
3 4
5
6
View from
rear of
connector
Screen PTT / Mic
Speaker
Figure 4-3 - Hirose connector
4.3 Commissioning
This section covers the tests, which should be undertaken prior to handover of the radio to the end
user. All of the following tests can be carried out without having to gain access to the interior of the
radio.
Recommended Test Equipment
The alignment and performance test procedures assume the use of the following equipment. The
functions of most of the equipment may be found in a “Communications Test Set”. This type of
equipment is available from a number of test equipment manufacturers.
Throughout this book reference will be made to the use of the Communications Test Set. Where
applicable, the equivalent discrete item of test equipment may be used.
DC POWER SUPPLY
RADIO
VOLT METER
OSCILLOSCOPE
COMMUNICATION TEST SET
DEMOD
AF IN
AF OUT
. .
RF
TEST BOX
S 2055 K
Figure 4-4 – Commissioning Test Setup using SK2055 Service Kit