MITSUBISHI ELECTRIC X50 - Manual (Page 10)

EN – 10
Basic connections
This projector can be connected to equipment such as PC, VCRs, video cameras and DVD players.
Important:
• Make sure that your equipment is turned off before connection.
• Plug in firmly and unplug by holding the plug, not by pulling the AC power cord.
• If connected units are set too close to one another, the image may be affected.
• Refer to the user manual of each component for details of connections.
Projector + AV equipment
Important:
• Match the color of video and audio plugs on the AV cable with the connections.
• S-video signals take priority over video signals. If you input both S-video signals and normal video signals at
the same time, the normal video input automatically is inhibited.
VCR etc.
to S-video
input
to video
input
to audio
input
to S-video
output
to video
output
to audio
output
Connect either one of these.
Ferrite core
• Speaker output is mono.
• Select AUDIO MODE 2 to hear and to sound for the VIDEO. (Refer to page 16).
• When connecting audio output of equipment which audio output is mono, connect to audio input L terminal.
Projector + DVD player or HDTV decoder
Some DVD players have output terminal for 3 line fitting (Y, C
B
, C
R
). When connecting them to the projector,
connect to COMPUTER IN of the projector. In this case, set “ Y, C
B
, C
R
” for COMPUTER INPUT setting in SIGNAL
menu.
DVD player generally has SDTV system component
video output (Y, C
B
, C
R
) terminals. HDTV decoder has
HDTV system component video output (Y, P
B
, P
R
) ter-
minals. When connecting the projector with DVD
player or HDTV decoder, the signal cuircuit
automaticaly applied to either of them
.
In this case,
the COMPUTER INPUT in the SIGNAL menu becomes
[Y, C
B
, C
R
/Y, P
B
, P
R
].
• Y, P
B
, P
R
is an example of the terminal names for a HDTV decoder.
• The terminal name is different depending on the connected equipment.
• Use mini D-SUB 15 pin-BNC conversion cable for connection.
• Some DVD players may not project the image correctly.
• When connecting with HDTV equipment which has R, G, B output, set RGB for the COMPUTER INPUT in
the SIGNAL setting menu.
• Change the setting in the SIGNAL menu, when 525p signal is inputted. (Refer to page 20).
B G R
C B (P B ) Y C R (P R )
HD/CS VD
DVD player or HDTV decoder
No connection
to COMPUTER
IN
BNC-RCA connector
(optional)
Mini D-SUB 15 pin-BNC
conversion cable (optional)