Matrox Electronic Systems Matrox RT.X2 - Manual (Page 25)

17
Setting your system’s volume levels
7 Repeat steps 5 and 6 for every audio input source that you intend to use with
your Matrox RT.X2 system. For example, if you intend on recording audio
from a microphone, set the volume levels for the
Microphone input.
8 Click OK .
9 Click OK to close the dialog box.
For Windows XP
1 Double-click the speaker icon on the Windows taskbar.
¥ Tip If you don’t see the speaker icon on your Windows taskbar, run
Sounds and Audio Devices from the Windows Control Panel, select Place
volume icon in the taskbar , then click OK .
2 Choose Options > Properties .
3 From the Mixer device list, make sure that the audio device you want to use
with your Matrox RT.X2 system is selected.
4 Select the Playback option, then select all check boxes in the list. Click OK .
5 For each of the controls ( Line-in , Wave , etc.), make sure the Volume sliders
are at an appropriate level, such as at half-level. As well, clear all the Mute
check boxes.
¦ Note If you have an active audio stream connected to an input on your audio
card via the RT.X2 breakout box, you must mute the input to avoid hearing
the audio when you’re not working in Premiere Pro.
6 Choose Options > Properties .
7 Select the Recording option, then select all check boxes in the list. Click
OK .
8 For each of the controls ( Line-in , Microphone , etc.), make sure the
Volume sliders are at an appropriate level, such as at half-level. As well, if
available, clear all the Mute check boxes.
9 Close the dialog box.