Miele T 4462 C - Manual (Page 36)

Installation site
,
Make sure the dryer door can be
opened without hindrance after
installation.
Transporting the machine to its
installation site
When moving the machine you can
hold it by the lid where it protrudes to
the rear of the dryer.
To manoeuvre the dryer out of its
packing case to its installation site you
will also need to hold it by the front feet.
Building under a continous worktop /
in a row of kitchen units
The dryer should not be installed
next to a refrigerator or freezer. The
warm air expelled from the rear of
the dryer would increase the
temperature around the
refrigerator's/freezer's heat
exchanger causing the compressor
to run continuously.
If it is not possible to install the dryer
anywhere else, then the
refrigerator/freezer must be sealed
off from the dryer.
If you wish to push your machine under
a worktop and there is space to do this
without removing the lid , a building
under kit is not necessary. Otherwise
the building under kit is essential.
,
The building under kit * must be
fitted by a suitably qualified person.
The machine lid is replaced by a
coverplate. It is essential that the
coverplate is fitted to ensure
electrical safety.
The building under kit is supplied with
its own installation instructions.
N.B. When built under running times
may be longer.
– The electrical socket must be
located in an accessible position
near the machine.
With niche heights of:
– 840 mm, longer screw feet* are
required.
– 870/885 mm - 915/930 mm, one or
two height adjustment frames* are
required.
* Available as an optional accessory
from your Miele dealer or the Miele
Spare Parts Department.
Replacing the lid
If the lid has been removed in order to
fit a cover plate, ensure that, if the lid is
replaced, it fits securely into the rear
holders. Otherwise, it is not properly
secure for transport.
Installation
36