Maytag 760S - Manual (Page 30)

30
Suggestions on positioning the
dishwasher
The dishwasher can be built in, fully free-
standing or semi-freestanding.
CAUTION!
Connection to electricity, water and drain-
age must be carried out by a suitably quali-
fied person.
A. Built-in
The dishwasher can be built in under a
worktop with a working height of 820 - 870 mm.
The width measurement must be at least 600
mm. For additional measurements, see picture.
B. Freestanding
A freestanding dishwasher must be fitted with
anti-tilt. This comprises two fastening irons
which are screwed into place as illustrated.
The dishwasher is then pushed in so that
the fastening irons grip onto the rear feet.
The dishwasher cannot now tilt in the event
a load is placed on the open door. If the
dishwasher is to be fully freestanding, both
side panels and the work top should be
fitted. These accessories can be purchased
where you purchased the dishwasher.
Tip!
A machine with side panels and a counter
top (freestanding) can, of course, also be
installed as a built-in unit.
C. Semi-freestanding
If the dishwasher is positioned so that either
side is visible, a side panel can be fitted.
These accessories can be purchased
where you purchased the dishwasher.
820-870
570
600
175-230
50
50-105
820-
870
100-
150
550
570
20
Built-in installation
455-47
5
600
413
Freestanding installation
CAUTION!
A fully freestanding dishwasher must be
fitted with anti-tilt.
Installation