Maxon Telecom MODMAX MM-6280IND - Manual (Page 39)

HSDPA Standard At Commands Page 39 of 61 Version 1.2
+CGANS Opt.
Manual response to a network request for PDP context
activation
Not supported
+CGCLASS Opt. GPRS mobile station class Supported
+CGCLPAD
(GPRS only) Opt. Configure local triple-X PAD parameters
Not supported
+CGEREP Opt. Packet Domain event reporting Supported
+CGREG Opt. GPRS network registration status Supported
+CGSMS Opt. Select service for MO SMS messages Supported
1.32.1. Define PDP Context +CGDCONT
The set command specifies PDP context parameter values for a PDP context identified by the
(local) context identification parameter, <cid>. The number of PDP contexts that may be in a
defined state at the same time is given by the range returned by the test command.
A special form of the set command, +CGDCONT= <cid> causes the values for context number
<cid>
to become undefined.
The read command returns the current settings for each defined context.
The test command returns values supported as a compound value. If the MT supports several
PDP types, <PDP_type>, the parameter value ranges for each <PDP_type> are returned on a
separate line.
Table 28. +CGDCONT parameter command syntax
Command Possible response(s)
+CGDCONT=[<cid>
[,<PDP_type> [,<APN>
[,<PDP_addr>
,<d_comp>[,<h_comp>
[,<pd1>
[,…[,pdN]]]]]]]]]
OK
ERROR
+CGDCONT? +CGDCONT: <cid>, <PDP_type>,
<APN>,<PDP_addr>,<d_comp>, <h_comp>[,<pd1>[,…[,pdN]]]
[<CR><LF>+CGDCONT:<cid>,<PDP_type>, <APN>,<PDP_addr>,<d_comp>,
<h_comp>[,<pd1>[,…[,pdN]]]
[...]]
+CGDCONT=? +CGDCONT:
(range of supported <cid>s), <PDP_type>,,,(list of supported
<d_comp>
s),
(list of supported <h_comp>s)[,(list of supported <pd1>s)[,…[,(list of
supported <pdN>s)]]]
[<CR><LF>+CGDCONT:
(range of supported <cid>s), <PDP_type>,,,(list of
supported <d_comp>s),
(list of supported <h_comp>s)[,(list of supported <pd1>s)[,…[,(list of
supported <pdN>s)]]]
[...]]
Value
<cid>
: (PDP Context Identifier) a numeric parameter which specifies a particular PDP
context definition. The parameter is local to the TE-MT interface and is used in other
PDP context-related commands. The range of permitted values (minimum value = 1) is