Multi-Tech Systems ISI551PC - Manual (Page 12)

2-3
2.3 Hardware Installation Procedure
Perform the procedures in Table 2-1 to configure
and install the ISI551PC card into your ISA or EISA
bus host computer.
1 Make sure your computer and
any peripheral equipment
connected to it, are turned off.
Failure to do so may damage
both your ISI card and your PC.
The card may be installed in any
286-, 386- or 486-based
computer with an ISA or EISA
bus architecture.
2 Remove the cover of your
Table 2-1
Step Procedure
ISI Configuration and Installation Procedure
Figure 2-1. I/O Address Switch/IRQ Jumpers