Multi-Tech Systems ISI551PC - Manual (Page 13)

2-4
computer as instructed in your
computer’s documentation.
3 Locate the unused slot(s) which
you will be using for your ISI
card, and remove the slot
cover(s) per the instructions in
your computer’s documentation.
4a The figure below shows the
default settings for this card.
Record any changes made to
the Base I/O Address settings.
The default Base I/O Address is
2F8 (COM2). The valid range is
100H - 3F8 H; refer to Appendix
A for a full table of address
settings.
O(pen) = OFF
C(losed) = ON
Figure 2-2. I/O Address Default
Table 2-1 (cont'd)
Step Procedure
ISI Configuration and Installation Procedure