Manually drawing up lower thread, Вытягивание нижней нитки вручную, Manuelles heraufholen des unterfadens – Brother Star 60 User Manual

Page 55

Advertising
background image

43

KNOWING YOUR SEWING MACHINE

KENNENLERNEN IHRER MASCHINE

КРАТКОЕ ТЕХНИЧЕСКОЕ ОПИСАНИЕ МАШИНЫ

Manually Drawing Up

Lower Thread

When sewing gathers or darts, the lower thread can be manually
drawn up so that it will have some excess.

1. Pass the thread along the groove in the direction of the arrow,

and leave it there without cutting it.

The bobbin cover should still be removed.

2. While lightly holding the end of the upper thread, slowly turn the

balance wheel to the front (counter-clockwise) once by hand to
lower and then raise the needle.

3. Pull on the upper thread to draw up the lower thread.

4. Pull out about 10 cm (4") of both threads and place them toward

the back of the machine under the presser foot.

1

Upper thread

2

Lower thread

1

2

txt_Sp

Вытягивание нижней нитки

вручную

При пошиве изделий со сборками нижнюю нитку можно
вытянуть вручную, чтобы обеспечить нужный запас длины
нити.

1. Пропустите нитку вдоль прорези в направлении стрелки и,

не обрезая ее, оставьте ее там.

• При этом крышка шпульки должна быть снята.

2. Слегка придерживая конец верхней нитки, медленно

поверните маховик на себя (против часовой стрелки) на
один оборот так, чтобы игла опустилась в нижнее
положение, а затем вновь поднялась в крайнее верхнее
положение.

3. Потяните верхнюю нитку на себя для того, чтобы вытянуть

нижнюю нитку.

4. Вытяните свободные концы обеих ниток приблизительно

на 10 см (4 дюйма) и, направив назад, пропустите их под
язычки нажимной лапки.

1 Верхняя нитка
2 Нижняя нитка

Manuelles Heraufholen des

Unterfadens

Beim Nähen von Falten oder beim Figurnähen kann der Unterfaden
manuell heraufgeholt werden, so daß mehr Garn zur Verfügung steht.

1. Führen Sie den Faden in Pfeilrichtung entlang der Rille und belassen

Sie ihn so, ohne ihn abzuschneiden.

Die Spulenabdeckung sollte immer noch geöffnet sein.

2. Während Sie das Ende des Oberfadens locker festhalten, drehen Sie

langsam am Handrad nach vorne (entgegen dem Uhrzeigersinn), bis
die Nadel ganz angehoben ist.

3. Ziehen Sie am Oberfaden, um den Unterfaden heraufzuholen.

4. Ziehen Sie beide Fäden etwa 10 cm durch den Schlitz des Nähfußes

nach hinten heraus.

1 Oberfaden
2 Unterfaden

Advertising
This manual is related to the following products: