MITSUBISHI ELECTRIC MR-J3-T - Manual (Page 40)

Connections for the CC-Link network
NOTE You must install a terminating resistor on terminals DB and DB on the physical first and last
stations in the CC-Link network. The required ohmage of the resistor depends on the cable
length, please check the version V1.10 specifications for details.
Additional Connections Positioning via a CC-Link Network
5 - 32 MITSUBISHI ELECTRIC
Fig. 5-2: Connections between the servo amplifier and the CC-Link master module
CC-Link
Master module
(e.g. QJ61BT11N)
MR-J3-T