Motorola and V.32bis - Manual (Page 224)

C-44 Country-Specific Information
Countr
y
-S
pecific
Infor
m
a
ti
on
Make Busy backplanes are factory configured for Busy Out operation in their
country destination, as indicated in Table C-20 or Table C-21.
Warning
Only qualified service personnel should remove pin
jumpers. A qualified service person is one who is familiar
with product operation, trained in the technology of
electrically powered information processing and business
equipment and adequately aware of the hazards associated
with this equipment. Removal by unqualified personnel
could result in personal injury or equipment damage,
which could jeopardize your warranty and maintenance
agreement.
Users who are not qualified to perform this action them-
selves should contact Motorola or an authorized distributor
regarding available upgrade services.
Table C-20. Backplane Pin Settings for Busy Out, Modulus 9
Pin Pair Function U. S. A. and Canada: Other UI Countries:
Left
1
TIP and RING No jumper connector Connected with jumper
Right 1 Make Busy and Make
Busy 1 Connected with jumper No jumper connector; not
applicable
1 Inner backplane surface, as viewed from the rear of the Modulus.
Table C-21. Backplane Pin Settings for Busy Out, Modulus 21
Pin Pair Function U. S. A. and Canada: Other UI Countries:
Left
1
Make Busy and
Make Busy 1 Connected with jumper No jumper connector; not
applicable
Right
1
TIP and RING No jumper connector Connected with jumper
1 Inner backplane surface, as viewed from the rear of the Modulus.