Multi-Tech Systems MT5634ZPX-PCI-U/NV - Manual (Page 10)

MultiModemZPX Quick Start Guide
10
Using AT Commands to Configure Your Modem
Non-Windows users can configure the modem using AT commands. You
must enter these commands in your communication program’s terminal
window.
1. Run your favorite communication program or use PhoneTools
(located on the CD packaged with your modem) and open the
program’s terminal window.
2. To configure the modem for a specific country:
Type AT%T19,0, nn (where nn is the country code in hexadecimal
format
Press E
NTER
.
The message OK displays.
3. To verify the change:
Type ATI9.
Press E
NTER
.
The country code is displayed in decimal format, as in this example:
Country AT command Result code
(hexadecimal) (decimal)
Euro/NAM AT%T19,0,34 (default) 52
The complete list of country codes can be found on the Multi-Tech
Web site at
http://www.multitech.com/GlobalModem/config .
Step 5: Install the Software (PhoneTools)
You may use either the communication software included with your
modem or a third-party program. Communication programs designed
for Windows 98+ normally do not need to be manually configured,
since they use the Plug and Play configuration of the Windows modem
driver. Communication programs designed for other operating systems,
however, may need to be manually configured. If you need advice on
configuring software, please see the
User Guide.