M-AUDIO 1010LT - Manual (Page 46)

Transferring from DAT to Delta 1010LT
1. Connect the DAT’s coaxial S/PDIF output to the S/PDIF In of the
Delta 1010LT PCI host card, using a good quality cable.
2. Connect the 1010LT analog outputs 1 & 2 to some type of amplified sound
system. The sound system should be equipped with speakers or head-phones.
3. Because you will be recording from the S/PDIF input, you will need to set up
the Delta 1010LT to synchronize its master clock with the S/PDIF input. To do
this, open the Hardware Settings page of the control panel software. Under
Master Clock, select "S/PDIF In."
4. Next, you will need to tell your application software the expected sample rate.
We’ll use 44.1 kHz in this example. Therefore, on the Hardware Settings page,
set the "S/PDIF Sample Rate" to 44,100.
Delta 1010LT
WORDCLOCK
MIDI
S/PDIF IN
S/PDIF OUT
S/PDIF OUT
46