Miele T 4262 C - Manual (Page 25)

Problem Possible cause Remedy
The condenser unit
service panel will not
shut. The inner cover of the
condenser unit has not
been locked properly
and/or the condenser
unit has not been
positioned correctly. – Ensure that the condenser
unit is positioned correctly
and lock the cover.
– Check the rubber seals.
Water leaks from the
machine after the
condenser unit has
been cleaned. Fluff has collected at
the bottom of the
condenser unit housing. – Use a cloth to remove any
fluff from the inside of the
condenser unit housing.
Check and fault indicator lamps
Problem Possible cause Remedy
The Empty out
container indicator
lamp comes on. The condensed water
container is full or there
is kink in the drain hose. – Empty out the condensed
water container.
– Check the drain hose.
– Before starting a new
programme, first switch the
dryer off and then on again.
The programme has
been interrupted, the
indicator lamp for
Hand iron or Machine
iron is flashing, and
the buzzer sounds. There is no obvious
cause. – Switch off the dryer.
– Then switch the dryer back
on and start the programme
again.
If the programme stops again
and an indicator lamp flashes,
there is a fault. Contact the
Miele Service Department.
Problem solving guide
25