Miele T 4262 C - Manual (Page 33)

Connection to a sink drain outlet
The drain hose can be connected
directly to a sink drain outlet.
^ Remove the following from the back
of the dryer at the bottom:
Adapter
1 and hose clip 3 behind it.
^ Fit adapter 1 to the sink drain outlet
using nut 2 .
If this nut has a flat disc in it you should
take the disc out first. Important: if this
nut has a washer or seal in it this must
not be removed!
^ Attach the end of the hose to
adapter 1 .
^ Use a screwdriver to tighten hose
clip 3 up close to the nut.
If you no longer wish to use an
external condensed water outlet
,
Do not push the drain hose
back into the dryer. Doing this could
cause it to become kinked and
damaged in the dryer.
^ Loop the drain hose up.
^ Use a suitable cable tie to secure the
looped hose to the back of the dryer,
or simply lay the looped hose behind
the dryer.
^ Attach the open end of the drain
hose back onto the holder at the
back of the dryer at the top (see
holder
2 in "Pulling out the drain
hose").
Installation
33