Metrologic Instruments Cubit MS6520 Series - Manual (Page 13)

7
S CANNER P ARTS
A. Speaker
Serves as an audible indicator.
B. Green & Red LEDs
During normal operation, the green
LED is on. This indicates that the
laser is on and the unit is ready to
scan. On a successful read of a bar
code, the red LED will turn on.
After communication to the host is
complete, the red LED will turn off.
The LEDs are also used as
diagnostic indicators and mode
indicators.
C. Output Window
Laser light emits form this aperture.
D. PowerLink Cable
The IS6520/MS6520 scanner has a
10-pin modular jack. The 10-pin
modular plug on the PowerLink
cable connects into the
IS6520/MS6520.
M OUNTING H OLES
Each IS6520/MS6520 Cubit ® is
equipped with three threaded mounting
holes located on the back of the
scanner. The following diagram shows
the exact location of each mounting
hole. The mounting holes are 6
millimeters deep and are threaded for
use with 3 millimeter screws.
Caution: Using a screw that is longer
than 6 millimeters can
potentially damage the
scanner.
A
D
B
C