Metrologic Instruments Cubit MS6520 Series - Manual (Page 28)

22
T ROUBLESHOOTING G UIDE ( CONTINUED )
RS232 only
IS6520/MS6520 Series Troubleshooting Guide (continued)
SYMPTOMS POSSIBLE CAUSE(S) SOLUTION
Powers up OK
and scans OK
but does not
communicate
properly to the
host Com port at the host is
not working or
configured properly Check to make sure that the
baud rate, data bits, stops bits
and parity of the scanner and
the communication port match
and the program is looking for
"RS232" data
Powers up OK
and scans OK
but does not
communicate
properly to the
host Cable not connected to
the proper com port Check to make sure that the
baud rate, data bits, stops bits
and parity of the scanner and
the communication port match
and the program is looking for
"RS232" data
Powers up OK
and scans OK
but does not
communicate
properly to the
host Com port not operating
properly Check to make sure that the
baud rate, data bits, stops bits
and parity of the scanner and
the communication port match
and the program is looking for
"RS232" data
The host is
receiving data
but the data
does not look
correct The scanner and host
may not be configured
for the same interface
font Check that the scanner and the
host are configured for the same
interface font
Characters are
being dropped Intercharacter delay
needs to be added to
the transmitted output Add some Intercharacter delay to
the transmitted output by using
the MetroSelect Configuration
Guide (mlpn 00-02407)