MACKIE DIGITALXBUS X.200 - Manual (Page 44)

44
X.200
Digital X Bus
Floating Insert Send
• Click the Floating Insert Send drop-down box
to select where to send the channel’s fl oating
insert send. You can use any I/O card’s output.
Typically, you would use this to send the signal
to an external processor, and return the signal
to the channel using the Floating Insert Return.
Floating Insert Return
• Click the Floating Insert Return drop-down
box to select where to return the fl oating insert
signal. You can use any I/O card’s input.
Phase Reverse
• Click the Phase Reverse button to invert the
polarity of the signal by 180º.
Digital Trim
• The Digital Trim allows you to adjust the input
level just after the A/D converter and before the
channel DSP.
• Provides a method to trim the input signal when
using Digital I/O cards.
Delay
• Adds delay to the selected channel. Ranges
from 0 ms to 500 ms. This can be manually ad-
justed with the V-Pot, or automatically adjusted
when using the “Adjust Channel Delay” feature
(Channel > Adjust Channel Delay).
Bus Assigns
• Click the Bus Assigns buttons to assign the
output of the channel strip to Bus 1-8 and the
L-R bus.