MACKIE DIGITALXBUS X.200 - Manual (Page 45)

45
Owner's Manual
Owner
's Manual
Pre Insert
• The Pre Insert point is located just before the
channel DSP section.
• Used to insert a plug-in effect into the channel,
pre-DSP.
• Click the Pre Insert drop-down box to select a
plug-in from the available effects in the Effects
Rack.
Note: One or more plug-ins must be installed in the
Effects Rack (Ctrl+8) before a Pre Insert can be
selected or None will appear in the drop-down box.
• If it’s a stereo effect, a channel can be assigned
to the left or right input of the effect.
• The corresponding output of the effect is re-
turned to the channel’s Pre Insert point.
Post Insert
• The Post Insert point is located just after the
channel DSP section.
• Used to insert a plug-in effect into the channel,
post-DSP.
• Click the Post Insert drop-down box to select a
plug-in from the available effects in the Effects
Rack.
Note: One or more plug-ins must be installed in the
Effects Rack (Ctrl+8) before a Post Insert can be
selected or None will appear in the drop-down box.
• If it’s a stereo effect, a channel can be assigned
to the left or right input of the effect.
• The corresponding output of the effect is re-
turned to the channel’s Post Insert point.
Direct Output
• The Direct Output is located after the channel
DSP and just before the fader, mute, and pan
controls.
• Click the Direct Output drop-down box to assign
the selected channel’s Direct Output to the
output of any I/O card.
Direct Out Level
• The Direct Output Level control corresponds
to the LEVEL TO TAPE V-Pot control on the
console surface (T-OUT). It ranges from off (–
∞)
to +10 dB.